Cavity optomechanical systems have become a topic of great interest in recent years, and the coupled-cavity model is also a classic theoretical framework. This paper aims to construct a coupledcavity optomechanical system to study induced transparency, Fano resonance, and fast-slow light effects in such a system. By transferring phenomena typically studied in a single optical cavity to a coupled-cavity system, we analyze specific phenomena detected in optical and microwave cavities, such as transmission and absorption spectra, to investigate induced transparency. We also examine Fano resonance in the model by varying detuning, and study fast-slow light effects through group velocity. This paper first constructs the corresponding physical model, as shown in Figure 1. Based on the theoretical model, a reasonable Hamiltonian is proposed. By introducing appropriate dissipation and fluctuation noise terms, the Langevin equations of motion are derived. Next, the Langevin equations are linearized, and the resonant terms are retained to obtain O+ . The amplitude of the field modes is then derived using the input-output relations. Following the experimental data from referenced literature, a numerical simulation program is implemented in Mathematica. By substituting the relevant parameters and performing calculations, the results are obtained through simulation. For the first time, the interactions among photons, magnons, microwaves, and phonons— as well as the interplay between photons in the two cavities—are investigated in a coupled cavity optomagnomechanical system. Electromagnetically induced transparency (EIT), Fano resonance, and fast-slow light effects are studied in this coupled-cavity optomagnomechanical framework. Phenomena typically examined in a single optical cavity are extended to the coupled-cavity system, with specific observations analyzed separately in the optical and microwave cavities. When δ=ωb, the absorption spectrum splits, and the absorption peak decreases from its maximum to its minimum. This phenomenon arises from the disruption of quantum interference effects. The resonance condition suppresses the generation of Fano resonance. At the resonant frequency ω0, the group delay is greater than zero, indicating slow-light propagation, and this effect is enhanced with increasing coupling strength. Additionally, a group delay of τ is achieved. Meanwhile, on either side of the resonant frequency, the group delay peaks exhibit a decreasing positive value and an increasing negative value, respectively, signifying a gradual weakening of the slow-light effect and a corresponding enhancement of the fast-light effect. This paper investigates the MIT, MMIT, and OMIT windows in a coupled-cavity optomagnomechanical (OMM) system under a strong control field and weak probe field. The MMIT phenomenon is observed through nonlinear phonon-magnon interactions. Additionally, the photon-magnon interaction in the microwave cavity leads to MIT, while OMIT is achieved via the radiation pressure interaction between photons and nonlinear phonons in the optical cavity. The frequency of the probe field is tuned to interact with both the microwave and optical cavities. When the probe field couples with the microwave cavity, its absorption at the resonant frequency is significantly suppressed under optomechanical coupling, resulting in a pronounced optical switching effect on transmission. We analyze the asymmetric Fano resonance phenomenon, which reflects the existence of quantum interference mechanisms within the system and influences the fast- and slow-light conversion processes. Furthermore, by selecting appropriate coupling parameters, not only can the fast- and slow-light effects be enhanced, but dynamic switching between them can also be achieved.
下载: