This investigation aims at the Zr-doping in -TiAl alloy systems in which Ti (or Al) atoms are partly replaced and the impurity concentrations are 1/54, 1/36, 1/24 and 1/16 (molar ratio), respectively. The structural, energy, plastic and electronic properties of the alloys are calculated and studied by using the first-principles method based on the density functional theory and other physical theory. From geometry optimization results it is shown that doping with Zr can change the structural symmetry of the -TiAl systems. These results also suggest that the cubic degree of Zr-doped -TiAl alloys can be increased due to the Zr-substitution. For instance, the cubic degrees of Ti12Al11Zr and Ti18Al17Zr systems are enhanced distinctly, which are positive for improving the mechanical properties of the alloys. The average formation energies obtained indicate that the Ti atom replaced by Zr can slightly decrease the formation energy of the system (0.003 eV/atom); while Zr substituting the Al atom can increase the formation energies of the systems (0.07 eV/atom). Accordingly, when Zr atoms are introduced in the -TiAl system, they tend to substitute Ti atoms, and can also substitute Al atoms with a certain possibility. Thus, various Zr-doped -TiAl regions can be produced in the system. The integral effects are of significance for improving the performance of the -TiAl based alloys by means of Zr-doping method. Comparing the axial ratios of Zr-doped -TiAl systems with that of pure -TiAl system, we find that Zr substituting Al atom can reduce the axial ratio of the Zr-doped alloys, which is responsible for the ductility of the materials. It should be mentioned that when the impurity concentration is in the range of 1.85 at%-6.25 at%, the doping effect will be most distinct and the axial ratio of the alloys is close to unity. It is expected that the Ti12Al11Zr system has a good ductility for its axial ratio equals to 1.007. The band structures of Zr-doped -TiAl systems show that they all have metallic conductivities. After Zr atom substitutes the Al atom in the -TiAl system, the intensity of covalent bond between Zr atom and its nearest neighbour Ti atoms in Ti12Al11Zr system reduces evidently and the bond length increases (0.032 ), which is indicated by the obtained overlap population (decrease by 0.21) and the densities of states in the Zr-doped and pure -TiAl systems. These results in the decrease of average intensity of Ti-Al(Zr) bonds and the increase of metallic bonds in Ti12Al11Zr system, which is an important factor for improving the ductility of -TiAl based alloys.