The spall behavior of copper at ultra-high strain rate is studied by molecular dynamics simulation combined with an experimental analysis of laser ablation of a bulk copper target by femtosecond laser pulses. In the molecular dynamics simulation, two-temperature model is used, shock wave and spallation characteristics of copper shock-loaded by femtosecond laser are analyzed in detail. It is concluded that the evolution of pressure indicates a triangular waveform of the shock wave, and the spall strength of copper is about 19 GPa at strain rates ranging from 109 s-1 to 1010 s-1, while higher pressure would melt the sample and the spall strength decreases to 14.89 GPa. Normally, the spallation is characterized by the sample free-surface undergoing alternately acceleration and deceleration, and the spallation mechanism could be explained by void nucleation, growth, coalescence that leads to the final fracture. An experiment is conducted to achieve high strain rate load on copper. The driving laser has a pulse width of 25 fs and central wavelength of 800 nm, the thickness values of the shocked copper foils are (5025) nm, fabricated by electron beam sputtering deposition onto 180 upm cover slip substrates. The driving laser beam with maximum intensity 5.51013 W/cm2, is focused on the front surface of the copper through the transparent substrate. Movements of the free rear surfaces of the copper foils are detected by chirped pulse spectral interferometry, and the theoretical time resolution is 1.3 ps. As a result, the free surface displacement and velocity evolution profile of the shocked area are obtained in a single measurement, and the results directly show that the maximum free surface velocity is 0.43 km/s and no alternately acceleration and deceleration appears. According to the shock wave relations, the maximum pressure near free-surface is 8.18 GPa. Meanwhile, derived from the velocity evolution profile, the strain rate is 7.3109 s-1. Combining with the above molecular dynamics simulation results, it is concluded that there is no spallation in the copper foil. Furthermore, we recover the sample targets and observe the microstructures by using scanning electron microscope. The copper foils are peeled off, but no spall scab is observed, indicating that the internal stress is between the copper spall strength and the bonding strength of copper foil with the transparent substrate. Ripple structure on copper surface demonstrates the femtosecond pulsed laser has ablated the copper film, and the propagation of the shock in fs regime is sensitive to microscopic defects.