Gas breakdown is one of the key factors restricting the increase of power capacity around the outer surface of highpower microwave dielectric window. It is of great significance to conduct corresponding simulation studies. Compared with the fluid model, the particle-in-cell-Monte Carlo collision model has two advantages: firstly, the influence of numerical dispersion and instability problems is insignificant; secondly, it can accurately describe microphysical processes. Therefore, the breakdown characteristics on gas side of dielectric window are simulated by the particle-in-cell-Monte Carlo collision model. The two-in-one macro-particle merging method is introduced into the model, which greatly reduces the number of macro-particles tracked, so that the whole breakdown process can be simulated and analyzed. The results show that the spatial and temporal evolution of breakdown under the variable macro-particle weight is in good agreement with that under the constant macro-particle weight. This suggests that the two-in-one macro-particle merging method is applicable under the simulation conditions of interest in this paper, i.e., when the ratio of the effective electric field of microwaves to the pressure is between 1:76×103 and 1:41×10 ⁴V/(m·Torr). Since the yield of secondary electron emission is much less than 1, gas ionization is the dominant mechanism of breakdown on gas side of dielectric window. Electron ionization and diffusion lead to a significant increase in the density and thickness of the plasma over time. The peak of electron density does not appear at the dielectric surface, but at a position 100-150 μm away from the dielectric surface. This is because a large number of electrons are deposited on the dielectric surface, and the accompanying self-organized normal electric field drives the electrons away from the dielectric surface. Since the background gas pressure of interest in this paper is higher than the critical pressure corresponding to the maximum ionization rate (about 10 Torr), the ionization rate decreases monotonically with increasing pressure and leads to a slower development of breakdown. The accuracy of the particle-in-cell-Monte Carlo collision model is confirmed by comparing the simulated values of breakdown time with experimental data. This work provides an important theoretical basis for understanding and controlling the breakdown on gas side of dielectric window. The following figure (a) shows that the mean electron energy under the variable macro-particle weight agrees well with that under the constant macro-particle weight at 100 Torr. The following figure (b) shows that using the particle-in-cell-Monte Carlo collision model with a two-in-one macro-particle merging method allows the breakdown process to be considered when the plasma density increases by a factor of 108.